convergent flow的例句大全

The results of several cases show that the main part of the pressure drop takes place in the convergent flow area and the linear flow area, and the pressure drop in the divergent flow area is very little.

结果表明：井筒附近压降主要发生在汇聚流区域和炮眼内砾石层，而环空砾石层的压降相对较小；

Finite element simulation of melted polymer flow inside convergent flow slot

收敛流道内聚合物熔体流动的有限元模拟

The entry convergent flow pattern was observed with flow visualization technique when the resin melt flowed through a die featuring abrupt contraction in cross-section of channel and axial symmetry.

应用毛细管流变仪测量了在接近实际挤出工艺条件下低密度聚乙烯熔体的流变性质；应用流动可视化技术，观测了试样熔体流经突然收缩的轴对称口模时的入口收敛流型。

A preliminary study on the interaction of systems of various scales in the convergent flow in the heavy rain area

暴雨过程汇合流场不同尺度系统相互影响效应的初步研究

Axial velocity of the melts in the runner was higher and the radial velocity was symmetrically distributed, which showed a typical convergent flow feature;

流道内熔体有较高的轴向速率，径向速率对称分布，其流动特征为典型的收敛流动；

The initially discovered RDBs include depositions at the paleo-tide convergent flow and the paleo-flood tidal jet, fringing deposition around the palco-terrance.

初步发现的快速沉积体有古汇潮点快速沉积体、古涨潮射流快速沉积体和台地周边快速沉积体。

Based on the measurements of the conductivity and the Cl-concentration in water samples, the standard fitting curves of instantaneous injection method of radial convergent flow was hired to obtain the dispersion parameters of unconfined aquifers in test sites.

在对水样进行电导率及Cl-浓度测试的基础上，使用径向收敛流场瞬时注入标准曲线配线法求得试验场地潜水含水层的弥散参数。

Nozzle flow field of SRM was numerically simulated with Fluent software. The effects of nozzle convergent half angle, radius of curvature on upstream of throat section and length of throat cylinder on flow field are investigated.

用Fluent计算流体力学软件对固体火箭发动机喷管流场进行了数值计算，研究了喷管收敛半角、喷管喉部上游圆弧曲率半径和喉部圆柱段长度对喷管流场的影响。

The swirling flow effect on the mass flow rate of convergent nozzle is analysed.

分析了进口气旋对收缩型喷管流量的影响。

Theoretical Calculation on the Behavior of Gas-Powder Flow Passing through Convergent Nozzle

收缩喷嘴中气粉流行为的理论计算

The results show that the extensional flow of melt in convergent die results in intense entrance elastic effect and distinct extrusion swell in conical die with different angles.

结果表明，不同角度圆锥口模挤出过程中，熔体在收敛流道受到拉伸流变，导致强烈的入口弹性效应，表现出熔体在不同角度圆锥口模挤出时有不同的挤出胀大比。